Abstract
Aiming at the drawbacks of conventional Type-C interfaces, including interference imposed by the USB channel on the audio channel during negative voltage transmission, mutual coupling of parasitic capacitances generated by multiple independent switches, and severe degradation in the transmission performance of high-speed USB signals, this paper proposes a single-path analog switch adopting a three-stage series NMOS topology. Combined with a charge pump circuit, a gate driving circuit and a dynamic body selection circuit, the proposed structure achieves prominent improvements in USB performance. Post-layout simulation verification based on a 0.18 μm process demonstrates that the variation in on-resistance of the audio channel reaches 0.11 Ω, the off-state isolation at 1 kHz is -111 dB, and the total harmonic distortion (THD) of audio signals is 0.003%. For the USB channel, the on-resistance is 3.75 Ω with an off-state isolation of -128 dB at 1 kHz and a -3 dB bandwidth of 1.49 GHz. At the operating frequency of 240 MHz, the differential return loss is -14.132 dB and the differential insertion loss is −0.84344 dB. The signal impedance matching and transmission attenuation satisfy the signal‑integrity requirements for high‑speed USB2.0, and the eye diagram remains complete without eye closure at 480 Mbps. Capable of transmitting both high‑speed digital signals and bipolar analog audio signals, the proposed design meets the hardware application requirements for lightweight terminals with Type‑C interfaces
Key words
Analog Switch /
On-Resistance /
Charge Pump /
Off-Isolation /
Bandwidth /
Eye Diagram
Cite this article
Download Citations
Design of USB and Audio Multiplexing Analog Switch for Type-C Interface[J]. Integrated Circuits and Embedded Systems. 0 https://doi.org/10.20193/j.ices2097-4191.2026.0127
{{custom_sec.title}}
{{custom_sec.title}}
{{custom_sec.content}}